Atelier 700Open the shop

Giant Escape 3 (2024)

We have not verified this bike yet

11 of the 16 measurements are on file; 0 confirmed by two independent sources. Without enough evidence, fit stays “unknown.”

Only universal parts (lube, tools, bar tape) are offered for this bike until verification.

Representative silhouette: Flat-bar commuter. Explore the bike’s regions.

Find this bike

Confirm the year, build and size with the seller.

The Giant Escape 3 (2024) is a commuter bike — representative silhouette: Flat-bar commuter. We have read 1 specification sheet (Giant Bicycles) and recorded 15 fit facts from it. 11 of the 16 measurements a commuter bike needs to answer fit questions are on file; 0 are confirmed by two independent sources. Where a measurement is missing, we say so below — we do not guess.

Seatpost diameter27.2 mm
Seatpost shapeRound
Maximum tyre width (frame)45 mm
Wheel size (ISO bead seat)700c / 29" (ISO 622)
Brake mount, frontCantilever / V-brake posts
Brake mount, rearCantilever / V-brake posts
Rotor interface (hubs)No rotor interface (rim brake)
Brake actuationCable rim brake
Brake pad shape (fitted calipers)Rim pads: V-brake / linear-pull threaded stud (M70T4 / S70C, 70 mm)
Freehub bodyThreaded freewheel hub (1.37" × 24 tpi)
Rear speeds7 speeds
Shift actuationMechanical (cable)
Chain standard6 / 7 / 8-speed (7.1 mm)
Stem bar-clamp diameter (fitted stem)25.4 mm
Handlebar clamp diameter (fitted bar)25.4 mm

Confidence: every fact above comes from a single cited source — "derived" on our lattice; none is verified by a second independent publisher yet. A verdict that rests on a safety-critical fact therefore stops at "unknown" rather than "fits".

Not on file (required for a commuter bike): Bottom bracket shell · Derailleur hanger · Rear axle spacing · Front axle spacing · Pedal thread. The sheet we read does not state them; until a source does, every fit question that needs one of these reads "unknown" — or "unknown — safety-critical" where a guess could hurt you.

Why do so many verdicts on this bike read "unknown"?
Because a verdict needs the bike's measurement for every dimension a part requires, and 5 of the 16 required measurements are not on file. "Unknown" means we could not check — not that it fits, and not that it does not.
Will the verdicts change?
Yes. When a second independent source confirms a measurement — or a first one states a missing one — the verdicts are recomputed from the new facts. Nothing on this page is typed by hand.

Regions of this bike

Not on file (required)

  • Bottom bracket shell
  • Derailleur hanger
  • Rear axle spacing
  • Front axle spacing
  • Pedal thread

Sources

The spec sheets we read. Every fact above cites one of them.

Source limitations: Left absent: axle spacings (hubs line says 'alloy, 32h' only), steerer, bb_shell ('cartridge' only), pedal thread.

The shop · Atelier 700